Singleton

Aust. 02 6571 5177 or Int. +61 2 6571 5177

Toggle Nav
My Cart
breadcrum-img

How To Apply Water$ave Plug & Seep

    • If your dam has water in it & is currently leaking then now would be the best time to apply. The pressure of the water leakage creates the suction needed to draw the hydrating polymers into the problem areas & seal the leaks.
    • If you do not have any water in your dam yet. You can apply Water$ave Plug/Seep as your dam is filling up after rain, this ensures a neat & even coverage.
    • If you know where the leak is then you can concentrate your application to that area. It is also recommended that the rest of the dam be treated as well & this can be done when the dam is full or is at least above the problem area.
    • Do not under apply. Apply product at no less than the recommended rates.
    • For a fast leak. Apply at 100gm/m2. A fast leak is a noticeable reduction over days & weeks.

    • For a slow leak. Apply at 75gm/m2. A slow leak is a noticeable reduction over months.
    • You can work out how much product you need. By using our online Water$ave Plug & Seep Polymer Calculator.
    • Remove any deep silt, livestock & dense reeds. They can impede the polymers ability to get to the outflows.
    • Just sprinkle over the surface of the water. On a quiet day with no wind or rain & when the dam is not overflowing.
    • Distribute it as if you are 'feeding the chickens'. At the recommended rates.
    • Cast out gently no more than 1.5m. By hand, scoop or fertiliser spreader from a small dinghy for best results.
    • Be careful not to separate the blend. Or go through the polymer while applying to the water surface.
    • A boat is recommended. To make sure that the application is spread evenly all over the dam without separating the blend.
    • Allow 12 - 48 hrs. To hydrate, expand & sink towards the outflows.

    • Then allow 2 - 10 days. Depending on the rate of leak for the polymers to start incorporating into the soil structures.
    • For more information. Please visit our Water$ave Plug & Seep FAQ page.

Water$ave Plug or Seep Application - Short Video

  • Connection To Slow For Video? Click Here to view the How To Apply Water$ave Plug or Seep Photo Slideshow

TESTIMONIALS

We had a seeping dam and being at the start of the watering season, we did not have the choice of emptying our stock and domestic dam on our Central Victorian property. Im naturally a sceptical person but after contacting Polymer Innovations fe...

- Joe Helper

Leak progress is still very good.  Your WaterSave product is fantastic !

I just wanted to send you a note, if you have another United States customer who is somewhat skeptical of your product.  If you want, you can provide the...

- George Graber

Our dam had been leaking badly for the past 2-3 months since it got full. I applied your Water$ave Seep at the recommended rate & within 2 days the leak had stopped & a week later the ground had almost dried out. We are really impressed...

- Frank & Jenny Bendigo, VIC

Our dam has stopped leaking completely within 3 days of using the Watersave Seep on dam floor & wall. Can’t thank you enough for your thoroughness in getting every bit of detail about our dam through questions, photos I sent through & google to ma...

- Joanne & Jay Astill Grose Vale, NSW

TOP