Singleton

Aust. 02 6571 5177 or Int. +61 2 6571 5177

Toggle Nav
My Cart
breadcrum-img

My Dam Won’t Hold Water After Rain, What’s Going On?

My Dam Won’t Hold Water After Rain, What’s Going On?

It’s a common frustration for farmers & rural landholders. Your dam fills up after good rainfall, only to drop again within days. It looks full one week & half empty the next. If this sounds familiar, your dam isn’t just losing water. It’s leaking.

 

Why Rain Doesn’t Fix the Problem

Rainfall can temporarily refill your dam, but it doesn’t repair the underlying issue. When your dam fills, water pressure increases. This pressure forces water into cracks, tunnels & weak soil zones within the dam structure. Resulting in water escaping faster even though the dam looks full.

 

Signs Your Dam Is Leaking After Rain

If your dam drops quickly after rainfall, look for:

  • Wet patches below the dam wall
  • Soft or slumping areas along the embankment
  • Cracks forming or widening
  • Unusual green vegetation outside the dam
  • Water disappearing faster than evaporation would allow

These are clear indicators that the dam structure is compromised.

 

Why Waiting Makes It Worse

Each rainfall event increases pressure on the dam. Over time, this can:

  • Enlarge leak pathways
  • Wash out soil from the dam wall
  • Increase the risk of structural failure
  • Lead to costly earthworks or rebuilds

What starts as a minor leak can quickly escalate.

 

The Right Way to Fix It

The key is not to wait for the dam to empty but to act while it’s full. Water$ave Dam Sealer is designed specifically for this situation. Water$ave is:

  • Applied to the water surface
  • Drawn into active leak zones
  • Expands to seal cracks & voids internally

This means you can treat the leak without draining the dam.

 

Why It Works So Well

Unlike traditional methods, Water$ave uses the dam’s own water pressure to carry the product to the problem area. This allows it to:

  • Target leaks precisely
  • Works for both base & wall leaks
  • Adapt to soil movement over time

Results are typically seen within 7–10 days.

 

Don’t Rely on Rain, Fix the Cause

Rainfall is not a solution. It’s only masking the problem. If your dam won’t hold water after rain, it’s time to take action before more water & money is lost.

 

Keep every drop where it belongs.

Learn more about Water$ave Dam Sealer or request a FREE dam assessment today.

 

 

Related Products

TOP